ADS 335c Spécifications télécharger pdf (Page 43)

Connecting Directly to the Unit

After the module is installed, attach it to the end of the Y-adapter ex-

tension cable as shown in the following diagram. To connect it to the

unit, insert the extension cable's splitter plug into the Network socket

on the back of the unit and your system is ready to use.

LGC-2000 direct connection to GPS unit.

NOTE:

The extension cable’s shorter branch will have a 60-ohm terminator at-

tached to it. Do not remove this terminator. When you're not con-

necting to a NMEA 2000 buss, you must leave the terminator con-

nected to this socket for your antenna/receiver to function correctly.

Connecting to a NMEA 2000 Network

The LGC-2000 can be connected to a NMEA 2000 buss, providing GPS

information to any Lowrance GPS units attached to the buss. Contact LEI

Extras (look inside back cover for accessory ordering information) for a

NMEA 2000 buss adapter cable if you would like to do this.

There are two ways to connect the antenna to a NMEA 2000 network

port. One method (shown in the following image) is to use the extension

cable's Y-adapter to connect both the antenna and the unit to the same

network port. To do this, simply remove the 60-ohm terminator shown in

the previous image and attach the NMEA 2000 buss adapter cable to the

shorter branch of the extension cable's Y-adapter. Connect the NMEA

2000 buss adapter cable's other end to an available network port.

LGC-2000 and GPS unit connection to NMEA 2000 buss.

You can also attach the antenna to a remote port on the network, and

pass position information along the network. To do this, simply attach the

25' Y-adapter

extension cable

60-ohm

terminator

LGC-2000

To unit

Splitter plug

LGC-2000

To NMEA 2000

network port

25' Y-adapter

extension cable

To unit

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 215 216

Pas de commentaire

ADS 335c Spécifications Page 43